Management SNMP: (v1), Telnet, serial console (CLI), HTTP

RFC Standards: RFC 1215, RFC 1493, RFC 2674, RFC 1157, RFC 1149, RFC 1643, RFC 1213, RFC 1757, RFC 2131

SNMP Traps: Cold start, warm start, link down, link up, authentication failed, up to 3 trap receivers configurable

Software Upgrade: TFTP-based firmware upgrade

Port Trunk: Supports IEEE 802.3ad with LACP function. Up to 3 trunk groups with up to 4 ports each configurable.

Spanning Tree: 

• IEEE 802.1D Spanning Tree
• IEEE 802.1w Rapid Spanning Tree

VLAN: 

• Port-based VLAN
• IEEE 802.1Q Tag VLAN
• Supports up to 256 static VLAN groups and up to 2048 dynamic VLAN groups (available VLAN IDs: 1 to 4094).

Class of Service (CoS): Supports 4 queues per port. Weight Round Ratio (WRR): High, Mid-High, Mid-Low, Low (8:4:2:1).

Quality of Service (QoS): Port-based, tag-based, IPv4 Type of Service (ToS), IPv6 Different Service

IGMP Snooping: up to 256 IGMP (IGMP v1 and v2) groups

Port-Based Security: MAC address filter inbound and outbound, source MAC addresses can be configured statically (up to 50 MAC addresses per port)

Port Mirror: 3 port mirror types available: RX only, TX only, RX and TX. Up to 8 port mirror entries configurable.

Bandwidth Control: 

• Incoming packets (broadcast, multicast, unicast): rate can be limited.
• Outgoing packets (all packets): configurable rate (64 kbps to 64 Mbps or 256 Mbps for one Gigabit port)

Authentication: Supports IEEE 802.1X Authentication (RADIUS Server), Reject, Accept, Authorize, Disable

DHCP: DHCP client function

Packet Filter: Broadcast Storm Packet Filter

Management IP Security: Access to the management functions (SNMP, Telnet, Web GUI) can be limited to specific IP addresses (up to 10).

System Log: Supports remote log server, up to 1000 local log entries.

SNTP: Supports RFC2030 Simple Network Time Protocol.

Configuration File: Download and upload of configuration files in binary format

PoE Management: 

• PoE Enable/Disable: enables and disables PoE function.
• Power Limit by Classification: Enables or disables PD power levels to delimit the output performance at the PoE port correspondingly.
• Power Limit by Management: feeding according to priority. The priority can be set per port. As soon as the power consumed reaches the maximum performance of the switch, the feeding to ports with low priority is disabled..